Question: Is 130 Too Hot For Water Heater?

Should both thermostats on water heater be set the same?

The majority of electric water heaters have two thermostats: an upper and a lower, located under two control panels.

To ensure your electric water heater works as efficiently as possible, you should set both of the thermostats at the same temperature..

Can a water heater explode?

High internal temperatures and pressure can contribute to a water heater explosion. Units are equipped with safety mechanisms to prevent levels from becoming excessive, but when malfunctions occur, an explosion may result. … Gas leaks also create the potential for a hot water heater explosion and the risk of a fire.

How do you kill bacteria in a hot water heater?

You can do that in one of two ways. Up the thermostat setting as you chlorinate, or while the chlorine is going into the water heater you place a UV-C sanitizer light on the water supply. They cost in the upper $400 range and will kill 99.9 percent of the bacteria that passes it.

Does 130 degree water kill bacteria?

At 140 degrees, Legionella die within about 30 minutes; at 130 degrees, it can take as long as 6 to 8 hours to kill the bacteria; at 120 degrees ─ the recommended temperature for conserving energy ─ Legionella will survive but won’t multiply. Temperatures below 120 degrees encourage the bacteria’s growth.

Is 150 degrees too hot for water heater?

The recommended setting for household water heaters is not 150 degrees, but slightly less _ 140 degrees. At that temperature, the water is hot enough to clean dishes and provide a steamy shower, but not so hot that it’s dangerous.

At what temperature does water sanitize?

Water temperature must be at least 180°F, but not greater than 200°F. At temperatures greater than 200°F, water vaporizes into steam before sanitization can occur. It is important to note that the surface temperature of the object being sanitized must be at 160°F for a long enough time to kill the bacteria.

What is a dangerous water temperature?

When water temperatures are between 60 and 70 degrees it becomes progressively more difficult to control your breathing. It becomes very dangerous in water temperatures between 50 and 60 degrees. You lose the ability to control breathing in this temperature range, according to the National Center for Cold Water Safety.

Can a water heater overheat?

An overheating water heater can be a safety hazard to you and your family. When your water heater starts overheating it can cause serious problems. Not only could the water be hot enough to burn your skin, problems in the hot water tank with the pressure of the system could damage the water heater.

How hot is too hot for water heater?

120 degrees FahrenheitThe Consumer Product Safety Commission (CPSC) recommends setting the water heater at no more than 120 degrees Fahrenheit (49 degrees Celsius) to prevent scalding. Not to mention, a water heater that is set too high can unnecessarily increase your electricity bill.

Is 125 too hot for water heater?

If you invest in one or more thermal protection devices to protect against overly hot water, the water heater could be safely set a little higher than 125 degrees. Most water heaters don’t have a thermostat control that is calibrated in such a way that you can just dial in 125 degrees.

Will 150 degree water kill you?

According to the Center for Disease Control, water stored at less than 150 degrees will permit the growth of numerous bacteria that can cause us illness. … –131 degrees is the temperature in degrees Fahrenheit that is required to kill the Legionella bacteria in a water heater.

Is 140 too hot for water heater?

Professionals recommend keeping your water heater set at a temperature between 130 and 140 degrees Fahrenheit. Any higher, or lower, could actually be dangerous for you and your family. While turning the temperature up higher can result in burns, turning it lower than the recommended setting can also be dangerous.